Product Description
For alignment control between a roof truss and nonbearing walls; the 1 1/2" slot permits vertical truss chord movement when loads are applied.
Material
- 18 gauge (43 mil)
Finish
- Galvanized (G90)
Installation
- Use all specified fasteners; see General Notes.
- Use STC or DTC depending on required loads. STC, installed with DS drywall stop, helps prevent fasteners tearing through the ceiling drywall (see installation illustration).
- Use STCT where truss or rafter is separated from the top plate of the nonbearing wall.
- Install slot nails in the middle of the slot.
- Products not intended for floor applications due to the frequency of floor joist deflections and potential for squeaks.
Please Note: This product image may represent a range of products; it may not be an exact representation of the product purchased.
Other Details
By ManufacturerProduct Videos
Custom Field
GTIN 20044315810002
